Filter
Top Products
GB - 14
OPTIONAL CONTROLS
Primer Bulb
Push the primer bulb in to add fuel for easier
engine start.
Wheel Drive Control (self-propelled
models)
NOTE: Engine must be running for wheel
drive to propel unit.
To drive forward:
Slowly pull the wheel drive control toward
you until you reach a comfortable ground
speed. Hold the wheel drive control in this
position to maintain the speed.
To stop:
Release wheel drive control.
Speed Control Knob
The speed control knob stops the wheel drive
control’s travel which limits the unit’s
maximum forward speed.
Turn the speed control knob
counterclockwise to increase the unit’s
maximum forward speed. Turn the speed
control knob clockwise to decrease the unit’s
maximum forward speed.
Fuel Shutoff Valve
IMPORTANT: The fuel shutoff valve MUST
be in the closed position prior to transporting
the unit.
Open the fuel shutoff valve to operate the
unit. Close the fuel shutoff valve when
storing, transporting or servicing the unit.
Fuel shutoff valve
open.
Fuel shutoff valve
closed.
FILLING THE FUEL TANK
To add fuel to fuel tank:
1. Put unit in open or well-ventilated area.
2. Stop engine and allow to cool.
3. Clean fuel cap and surrounding area.
4. Remove cap.
IMPORTANT: See engine manual for correct
type and grade of fuel.
5. Fill fuel tank to within 1/4 in. (0.63 cm)
below bottom of filler neck with unleaded
gasoline. See SPECIFICATIONS on
page 25.
6. Replace fuel cap and tighten.
7. ALWAYS clean any spilled fuel.
MOWER SET-UP
CAUTION: Unit will move forward
at engine start if wheel drive
control is engaged. ALWAYS
release wheel drive control before
starting unit.
Figure 12
Figure 13
CAUTION: DO NOT operate
mower unless either side
discharge cover or side discharge
deflector is installed. Thrown
objects may cause damage or
injury. Never operate unit with rear
door open unless grass bag is in
place.
CAUTION: If clog or obstruction
prevents grass flow, release
engine/blade control and
disconnect spark plug wire before
attempting to clear away any
clogs.