Filter
Top Products
21
30SB, 36SB, 45SB
Snow BEAST
Snow BEAST Snow Blower
V8.10.25.12
Check & Replacing the Transmission Drive Belt
If belt needs to be changed or altered for any reason, the
belt is located in the front of the snow blower behind the
discharge chute and in front of the wheels.
1. Remove the cover that is protecting the snow
blower’s belts. Remove the screws and simply lift
up the cover.
2. Remove the black belt and replace with a new belt.
3. Attach the cover and all hardware as they were
when taken off.
IMPORTANT! The snow blower belts are adjusted to
ensure the augers stop turning within 5 seconds of
releasing the augers/impeller control lever. If you are
making any belt adjustments whatsoever, for your safety
and the safety of others around you, you must ensure the
belts are re-adjusted to achieve this design specification.
Check & Replacing the Augers/Impeller Belt
There are two located in the front of the snow blower
behind the discharge chute and in front of the wheels.
1. Remove the cover that is protecting the Snow
Beast’s belts. Remove the screws and simply lift up
the cover.
2. Remove the two belts and replace with new belt or
belts depending on the belt’s condition.
3. Attach the cover and all parts as they were when
taken off.
NOTE: Always change both belts at the same time.
Changing only one belt can lead to performance issues.
Also check for correct belt tension after changing belts.
Readjust if necessary.
Belt Spec: MXV4-370
Part# B08911
Service Adjustments