13
30SB, 36SB, 45SB
Snow BEAST
Snow BEAST Snow Blower
V8.10.25.12
High Mark
Step 10: Filling Oil and Gasoline
1. Fill the engine with SAE 5W-30 engine oil. Fill the engine with 1.2 to 1.5 quarts of oil. Fill up to the full level mark on the dip
stick. Do not overfill.
When checking oil, remove dipstick, wipe completely clean, insert dipstick into dipstick tube on the engine (do NOT screw
dipstick down), remove dipstick and observe oil level (detail below).
Keep oil level at the high run mark for longest engine life.
2. Check that the fuel filter is clean and fill the tank to the proper level leaving adequate space for fuel to expand when the engine
is running at its operating temperature. That level is about 0.75-1” below the top of the tank to ensure no gasoline leaks.
DANGER: GASOLINE IS HIGHLY FLAMMABLE AND
EXPLOSIVE. Do not add fuel while the engine is
running or is hot. Keep open flames, sparks, and heat
away from the fuel and store fuel in containers
specifically designed for that purpose. ADD FUEL
OUTDOORS ONLY. IF THE FUEL IS SPILLED, DO NOT
START THE ENGINE. Manually push the snow blower
away from the spill and wipe up immediately.
DANGER
Step 9: Headlight
1. Connect snow blower headlight wire plug to the headlight
bulb.
2. Connect the headlight bezel to the control panel.
A. Tilt headlight assembly and align tabs on the top
of the headlight bezel with the notches in the
control panel. Insert the notches into the panel.
B. Tilt headlight assembly down while gently
squeezing the headlight bezel and push headlight
into control panel.
Assembly Instructions
Need Help With Assembly?
(919)-550-3221
GASOLINE IS HIGHLY FLAMMABLE AND
EXPLOSIVE. FUEL LEAKS, A LOOSE FUEL TANK,
OR A LOOSE FUEL VALVE CAN LEAD TO
SEVERE INJURY OR DEATH. DO NOT OPERATE
THIS SNOW BLOWER IF ANY COMPONENT OF
THE FUEL SYSTEM IS LOOSE OR LEAKS
GASOLINE!
Check engine oil level before each use.
Maintain oil level between run marks on the
dipstick, and change oil according to the
maintenance schedule to maximize product life.
Low Mark