Filter
Top Products
Smart-UPS 750/1000/1500/2200/3000 VA 120/230 Vac Tower 14
Service and Support
Service
If the unit requires service, do not return it to the dealer. Follow these steps:
1. Review the Troubleshooting section of the UPS manual to eliminate common problems.
2. If the problem persists, contact APC Customer Support through the APC Web site,
www.apc.com.
a. Note the model number and serial number, located on the rear of the unit, and the date of
purchase.
b. Call APC Customer Support and a technician will attempt to solve the problem over the
phone. If this is not possible, the technician will issue a Returned Material Authorization
Number (RMA#).
c. If the unit is under warranty, the repairs are free.
d. Service procedures and returns may vary internationally. Refer to the APC Web site for
country specific instructions.
3. Pack the unit in its original packaging. If this is not available, refer to www.apc.com to obtain a
new set.
a. Pack the unit properly to avoid damage in transit. Never use foam beads for packaging.
Damage sustained in transit is not covered under warranty.
b. For the UPS, always DISCONNECT THE BATTERY before shipping in compliance
with U.S. Department of Transportation (DOT) and IATA regulations. The battery
may remain in the unit.
c. Internal batteries may remain connected in the XLBP during shipment (if applicable, not all
units have XLBPs).
4. Write the RMA# provided by Customer Support on the outside of the package.
5. Return the unit by insured, pre-paid carrier to the address provided by Customer Support.