Filter
Top Products
4
Z-1200II Operation
♦ Add fluid carefully to the liquid tank. Do not overfill the tank.
♦ Plug the remote control cord into the slot marked remote control on the back of the machine.
♦ Plug power cord into a grounded electrical outlet. Turn the power switch to “ON” on the back of the
machine. The red light on the remote will turn ON once the machine is plugged into a power outlet and the
ON/OFF switch is turn ON. The unit will take a couple of minutes to warm up the heater. During this time
the machine cannot generate fog. The green light on the remote will turn ON once the machine is ready to
produce fog.
♦ To emit fog press the green button on the remote. Z-1200II is controlled via the Z-8 remote control.
♦ For detailed instruction on the various functions on operating your Z-1200II Fog Machine, see the section
titled “Remote Control Operation”.
Important: Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can
permanently damage the unit.
Z-1200II: Your model includes a mounting bracket designed for overhead installation; it may be
installed at floor level or suspended overhead. If the unit is to be mounted using the bracket, it is
important that the fog does not shoot directly at any one’s face. Whatever installation method
you choose, do not allow the unit to have more than a 25 degree angle of inclination.
Z-1200II Description
Note: A fluid level sensor is installed on the unit. The machine will stop to fog if the fluid is lower than usable
level.
If you experience low output, pump noise or no output at all, unplug immediately. Check fluid level, the
external fuse, remote control connection and power from the wall. If all of the above appears to be O.K.,
plug the unit again. If fog does not come out after holding the remote button down for 30 seconds, check
the hose attached to the tank to make sure there is fluid going through the hose. If you are unable to