Filter
Top Products
3
♦ If the supply cord is damaged, it must be replaced by manufacturer or its service agent or similarly qualified
personnel in order to avoid a hazard.
♦ The output nozzle becomes very hot during operation (200°C). Keep flammable materials at least 50 cm
away from the nozzle.
♦ Always allow your ANTARI Fog Machine to cool down before attempting to clean or service it.
Danger of Explosion
♦ Never add flammable liquids of any kind (such as oil, gas, perfume) to the fog liquid.
♦ Use only high-quality, water-based fog liquid that your dealer recommends. Other fog liquids may cause
clogging or “spitting”.
♦ Always make sure there is sufficient liquid in the tank. Operating this unit without liquid will cause damage
to the pump as well as over-heating of the heater.
♦ If your ANTARI Z-1200II, Z-1500II or Z-3000II Fog Machine fails to work properly, discontinue use
immediately. Drain all fog liquid from the tank, pack the unit securely (preferably in the original packing
material), and return it to your ANTARI dealer for service.
♦ Always drain tank before mailing or transporting this unit.
♦ Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin or
eyes, rinse thoroughly with water.
Note: Pay attention to all warning labels and instructions printed on the exterior of your ANTARI Fog Machine
Unpacking & Inspection
Open the shipping carton and verify that all equipment necessary to operate the system has arrived intact.
The shipping carton should contain the following items:
1. One unit of Z-Series II Fog Machine with power cord
2. Mounting brackets with washers/screws (for Z-1200II)
3. Z-8 Multi-function remote control with attached cord (for Z-1200II)
4. Z-20 multi-function remote control with attached cord (for Z-1500II & Z-3000II)
5. User Manual
If any equipment is missing contact your ANTARI dealer immediately.
Before beginning your initial setup on ANTARI Z-1200II, Z-1500II or Z-3000II Fog Machine, make sure that
there is no evident damage caused by transportation. In the event that the unit’s housing or cable is damaged,
do not plug it in and do not attempt to use it until after contacting your ANTARI dealer for assistance.
Setup
♦
Remove all packing materials from shipping box. Check that all foam and plastic padding is removed,
especially in the nozzle area.
♦ Place fog machine on a flat surface and remove fog liquid tank cap.
♦ Fill with high-quality, water-based fog liquid recommended by ANTARI dealer. Any other types of fluid can
damage the unit resulting in spitting and serious clogging problem. When filled, place cap back on liquid
tank.
Be careful not to exceed the maximum fluid level. DO NOT OVERFILL.
♦ Firmly attach the Z-8 or Z-20 control module cable to the connector inside the rear chamber of the machine.