Filter
Top Products
7. Press the “REC Button” (4-4,Fig.1) momentarily to start the data log function. The REC
symbol will be displayed on the LCD. The data logger function can save up to 1000 values of
measure (either Humidity &Temp. or Dew Point& Temp).
8. Press the “Logger Button” (4-6, Fig.1) and the meter will start logging. You will see the A
flashing on the top of the LCDevery time a logging event has occurred. The Aflashing will
match the number of seconds you set in the setup of the data logger function.
9. Ifthe Ain the top ofthe LCD and the lower display are flashing then,it indicates that the
memory is full. Please view the “Clears the existing saving data fromthe memory” section in
the “Advanced Measuring Procedures” section.
4-8 Manual Data Logger (set sample time to 0 seconds)
1. Press the “REC Button” (4-4,Fig.1) momentarily to start the data log function. The REC
symbol will be displayed on the LCD. The data logger function can save up to 1000 values of
measure (either Humidity &Temp. or Dew Point& Temp).
2. Press the “Logger Button” (4-6, Fig.1) every time you would like the meter to record a value.
You will see an A flash in the topofthe LCD. The meter willnotrecord another measurement
until youpress the“Logger Button” (4-6, Fig.1) again.
3. Ifthe Ain the top ofthe LCD and the lower display are flashing then,it indicates that the
memory is full. Please view the “Clears the existing saving data fromthe memory” section in
the “Advanced Measuring Procedures” section.
8