Filter
Top Products
4
4. Route the new long harness along the outer edges of the enclosures following the path of the
original wiring as closely as possible. Use tie-wraps when necessary.
5. Attach the new long harness to the transponder in the CTEG4M Enclosure. See figure below for
details.
Rear View CTEG4M Enclosure
6. Verify system functionality.
• Force the engine to crank, allowing failure to start. An error message should appear at
the head-end site.
• Turn the generator ON. Head-end site operators should see the engine status as ON.
• Turn the generator OFF. Head-end site operators should see the engine status as OFF.
Connect Power to the Enclosures
1. Reconnect the battery in the generator enclosure.
2. Switch the battery circuit breaker ON.
3. Switch the utility circuit breaker ON.
Utility Meter
XP7 connector
for transponder
Ground Bar
Transponder
Existing Wiring
harness for
Generator Control
A
: Cut the original
wire to Pin #7. Attach
the new long harness
wire to the plug side,
using a butt-splice.
N
ew long harness
B
: Attach the wire
previously cut from
Pin #7, to the ground
bar using a butt-
splice. (Wire NOT
included).