Filter
Top Products
1
Chapter 1 General Information
The Conversion Kit is used to provide additional status monitoring capabilities for the Generac-
Bowman generator.
Safety
This Safety Guide contains important instructions that should be followed during installation and
maintenance of the APC equipment and batteries. It is intended for APC customers who setup,
install, relocate, or maintain APC equipment. Changes and modifications to this unit not expressly
approved by APC could void the warranty.
Installation, initial start-up, and maintenance should be carried out by a qualified electrician.
Read the Safety Information included in the User’s Manual for the generator.
Failure to observe these warnings may result in serious injury, or death, or damage to the
equipment.
Electrical
Warnings
Do not work alone under hazardous conditions.
Do not handle any metallic connector before the power has been disconnected.
Servicing this equipment may require working with protective covers removed
and AC power connected. Use extreme caution during these procedures.
High current through conductive materials could cause severe burns.
When grounding cannot be verified, disconnect the equipment from the utility
power outlet before installing or connecting to other equipment. Reconnect the
power cord only after all connections are made.
Check that the power cord(s), plug(s), and sockets are in good condition.
Replacement of fuses or other parts must be with identical types and ratings.
Substitution of nonidentical parts may cause safety and fire hazards.
Overhead
Warnings
Never stand below anything while it is hoisted. Always wear a hard hat.
Lifting
Warnings
Transformer modules are heavy. Use proper lifting equipment and techniques
to avoid injury.
Battery
Warnings
Danger of explosion if battery is incorrectly connected or replaced. Replace
batteries only with same or equivalent type recommended by the
manufacturer.
Batteries must be recycled. Deliver the battery to an appropriate recycling
facility or ship it to the supplier in the new battery packing material.