Filter
Top Products
3
Power Shutdown Procedure
The generator power supply must be shutdown prior to installing the Conversion Kit.
1. Ensure that the CTEG4M Enclosure is NOT running on generator power.
2. Disconnect the cable from the negative (-) battery terminal in the generator enclosure.
3. Switch the battery circuit breaker to the OFF position.
4. Switch the utility circuit breaker to the OFF position.
Conversion Kit Installation
1. Open the generator enclosure.
2. Locate the gas solenoid valve and pull the two connectors off of the solenoid.
Front View Generator Enclosure
3. Replace the original wiring with the new long and short harnesses. See figure below for details.
Relay Pinout
N
o Connection
Relay to be
Tie-Wrapped
to Stand Off
Stand Of
f
Power Supply and
Transponder(s)
located in attached
enclosure.
Solenoid
Connectors on
Valve
Original
Solenoid Wires
Generato
r
N
e
w
Long Harness
N
ew
Long
Harness
N
ew Short
Harness
N
ew Short
Harn
ess
Original
Solenoid Wires
Condui
t