Filter
Top Products
OPERATION
TX235 02/07 Operation Section 4-11
© 2007 Alamo Group Inc.
OPERATION
Cutting Height Adjustment
1. Using the tractor hydraulics, raise the
mowers off the ground and support under it
with secure blocking so not to let the mower
drift down during maintenance.
2. Holding wheel and yoke assembly up,
remove quick-lock pin from top of gauge
wheel spindle. Position full length spacers
and 1/4" spacer as required. All spacers on
top of spindle tube allows for approximately
1/2" cutting height. Adjustments range from
1/2" to a maximum of 5" in 1/2" increments.
ROLLER ADJUSTMENT
Place roller bracketst in lowest position for cutting heights 5” to approximately 3”. Place in highest position for
1” approximately 1-1/2” cutting heights. Place in intermediate position for cutting heights 2” to approximately 3”.
8. DRIVELINE ATTACHMENT
The driveline yoke and tractor PTO shaft must be
dirt free and greased for attachment.
To connect the mower driveline to the tractor PTO
output shaft, pull the driveline yoke collar back and
align the grooves and splines of the yoke with
those of the PTO shaft. Push the driveline yoke
onto the PTO shaft, release the locking collar, and
position the yoke until the locking collar balls are
seated onto the PTO shaft. Push and pull the
driveline back and forth several times to ensure a
secure attachment. OPS-R-0003_D
When attaching the Implement input driveline to the Tractor PTO, it is important that the
connecting yoke spring activated locking collar slides freely and the locking balls are seated
securely in the groove on the Tractor PTO shaft. Push and pull the driveline back and forth
several times to ensure it is securely attached. A driveline not attached correctly to the
Tractor PTO shaft could come loose and result in personal injury and damage to the
Implement.
(S3PT-17)