Filter
Top Products
ASSEMBLY
SHD 03/09 Assembly Section 3-6
© 2009 Alamo Group Inc.
ASSEMBLY
IDLER ARM ASSEMBLY
Do not secure at this time.
1. Remove fasteners and shaft protector from end
of driveline. Lightly grease shaft. Install key and
driveline pulley. Do not secure at this time.
Image ASM-FL-0052
2. Align all three pulleys using a square to deter-
mine alignment. Use spacers and shims pro-
vided to hold alignment in place; then, secure
idler arm assembly with cotter pin. Secure driv-
eline pulley with fasteners removed in Step 1
above.
3. Install drive belt. Image ASM-FL-0053
4. Attach spring. One end is inserted in idler arm
spring arm hole; the other end is attached to the
long outboard bearing plate capscrew.