Filter
Top Products
ASSEMBLY
SHD 03/09 Assembly Section 3-2
© 2009 Alamo Group Inc.
ASSEMBLY
GENERAL
To help you assemble your new SHD FLAIL to your tractor, we provide you with drawings, instructions, and
information, if necessary, you may get more information or clarification from our Technical Services
Department over the phone.
IMPORTANT
Reference to the left or right side of the SHD FLAIL is determined while facing the front of the tractor from the
drivers seat.
Assemble the SHD FLAIL, step by step, as illustrated on the pages of this section. Small parts (bolts, nuts,
etc.>) required are packed in numbered plastic bags which correspond to assembly procedures and
illustrations in the manual.
The part quantities listed for an illustration pertain only to that phase of assembly. The quantity given
corresponds to the number of parts needed.
Large parts are not always listed next to an illustration, but they are usually easy to identify.
Whenever reference is made to parts listed for an illustration or elsewhere in this manual, the following
abbreviations are used:
BOLT-hex head bolt
LW-lock washer
PW-plain washer
When installing fasteners, PW and LW (generally installed in that order) are usually on the side of the fixture or
part being fastened that the hex lock nut is on. When only BOLT, LW and/or PW are required, they are
generally installed in that order. Some parts do not require a PW or LW. Refer to illustrations for exceptions.
Fasteners should be installed so they cause the least interference with other parts. When securing driveshaft
pulley to hub, tighten fasteners to 9lb-ft torque.
This manual makes reference to individual component parts, some of which may have been pre assembled at
the factory.
RH-right hand NF-national fine
LH-left hand MA-mechanical assembly
NC-national coarse WA-welded assembly