Filter
Top Products
© 2004 Alamo Group Inc.
2-4
HYDRO 15 (HY15)
SERVICE BULLETIN No. 002112
Alamo Industrial Technical Services Department
1502 East Walnut
Seguin, Texas 78155
830-372-2708
Blade Replacement Notice, Rotary Mowers:
Subject:
During random inspection of rotary mower blades, we determined that a small quantity of blades
may be of a quality lower than that which is acceptable to Alamo Industrial. These blades can be
identified by the Alamo Industrial Logo, Part Number and Date code that is stamped on the blade next
to the blade bolt hole (See Figure 1). Refer to the Blade Numbers listed in this bulletin and their
corresponding date codes to identify the blades to be replaced.
Service Required:
To prevent possible blade failures, the following repair procedure is deemed necessary.
Immediately inspect all Alamo Industrial Rotary Mowers to determine if they are fitted with blades
identified in this bulletin. Replace all blades that have matching part numbers and date codes listed on
the following pages. Inspect all of your Parts Inventory of blades to determine if any of these blades on
hand match the part numbers and date code. Only blade with matching part number AND date codes
will apply to this bulletin. Blade can be check without removing them as the part number and date codes
are on the underside of the blade.
Parts Required:
Rotary Mower Blades on mowers and / or in parts inventory should be replaced if numbers and
date codes match those listed.
Models: Any Rotary Mower using any of the blade Part Numbers
with the indicated date codes listed in this bulletin.
Date:
Dec. 21, 2000
Bulletin No:
002112
(Old # 122100A)
Parts:
100 % at Dealer Net
Labor:
Refer to Alamo Flat rate
manual for labor time
Termination Date:
Apr. 30, 2001
Old Parts Disposition:
Retain Removed Parts for
Recall
Continued Next Page
Figure 1
Mfg. Date Code
Underside
of Blade
Blade Bolt Hole
Blade P/N
Alamo
Logo
Torque Blade Bolt to
Specfications listed in operators
manual for the model being
repaired