Filter
Top Products
ASSEMBLY
800 01/11 Assembly Section 3-2
© 2011 Alamo Group Inc.
ASSEMBLY
Assembly of Moldboard to Mainframe
The Rhino 800 Blade is shipped from the factory
assembled except for the Moldboard. Optional 7”
or 8” Moldboards are attached to the Index Plate
by two 5/8” bolts in the top two mounting holes and
two 5/8” nuts through the lower holes of the Index
Plate. Torque bolts as required by chart on page
10. There is no further assembly required for the
basic unit.
Extra Equipment
End Plates - Bulk material such as dirt, snow, sand, or gravel can be moved by using End Plates. They are
easily attached by three "Klik" Pins.
Skid Shoes - To increase Blade life and prevent
gouging, adjustable Skid Shoes are available.
Attach one on each end of Moldboard using two 5/
8” x 3" plow bolts. Install plow bolts using top lock
nut, hardened washer & nut supplied with mold
board. Install one hardened flatwasher per bolt, the
skid shoe, then one more hardened flatwasher and
the locknuts. Skid shoe will be offset from
Moldboard. Tighten securely.