Filter
Top Products
OPERATION
PA91 02/08 Operation Section 4-33
© 2009 Alamo Group Inc.
OPERATION
When cutting foliage and fine shredding is desired, run the mower level or slightly lower in the rear so as to
keep the material in the mower until it is shredded. This will require more power but will shred better. When cut-
ting heavy foliage and fine shredding is not desired, raise the rear of the mower. This will allow the high volume
of material to be discharged and requires much less power.
Do not ride the clutch on the tractor. Mow in the appropriate gears to give the correct ground speed.
Extremely tall grass should be cut twice. Raise mower and cut twice the desired height. Cut the second time at
desired height at 90 degrees to first pass.
Remember, sharp blades produce cleaner cuts and use less power.
Before cutting, analyze the area to determine the best cutting procedure. Consider the height and type of
material and the terrain type: hilly, level or rough.
Do not mow with two machines in the same area except with Cab tractors with the windows
closed.
(SGM-11)
Mow only in conditions where you have clear visibility in daylight or with adequate artificial
lighting. Never mow in darkness or foggy conditions where you cannot clearly see at least
100 yards(90 m) in front and to the sides of the tractor and mower. Make sure that you can
clearly see and identify passersby, steep slopes, ditches, drop-offs, overhead obstructions,
power lines, debris and foreign objects. If you are unable to clearly see these type of items
discontinue mowing.
(SGM-1)
Avoid mowing in reverse direction when possible. Check to make sure there are no
persons behind the mower and use extreme care when mowing in reverse. Mow only at a
slow ground speed where you can safely operate and control the tractor and mower.
Never mow an area that you have not inspected and removed debris or foreign material.
(SGM-08)
Never operate the mower head tilted down where the operator can see the blades of the
mower. The blade could throw an object toward the operator causing serious injury or
death. Never operate the mower without an Operator Protective Structure. Always were
safety glasses and a hard hat. (Ops-0005-MISC)
M
any var
i
e
d
o
bj
ec
t
s, suc
h
as w
i
re, ca
bl
e, rope, or c
h
a
i
ns, can
b
ecome en
t
ang
l
e
d
i
n
th
e
operating parts of the mower head. These items could then swing outside the housing at
greater velocities than the blades. Such a situation is extremely hazardous and could result
in serious injury or even death. Inspect the cutting area for such objects before mowing.
Remove any like object from the site. Never allow the cutting blades to contact such items.
(SGM-06)