Filter
Top Products
OPERATION
1595 01/11 Operation Section 4-39
© 2011 Alamo Group Inc.
OPERATION
In case of mechanical difficulty during operation, place the transmission in the park
position, set the parking brake, shut down all power, including the PTO and the engine and
remove the key. Wait until all rotating motion has stopped before dismounting.
(SG-39)
Inherent hazards of operating the tractor and implement and the possibility of accidents are not left behind
when you finish working in an area. Therefore, the operator must employ good judgement and safe operation
practices when transporting the tractor and implement between locations. By using good judgement and
following safe transport procedures, the possibility of accidents while moving between locations can be
substantially minimized. OPS-L- 0031
Before transporting the tractor and loader, idle the
tractor engine. When transporting, carry the loader
as low as possible maintaining adequate ground
clearance and visibility. Reduce tractor ground
speed when transporting a load. Take extra care
when traveling over rough terrain or on slopes.
OPS-L-0011
Before transporting the tractor on a public roadway
or boarding a trailer for transport, the tractor brake
pedals should be locked together. Locking the
pedals ensures that both wheels brake
simultaneously while stopping, especially when
making an emergency stop.
Use extreme caution and avoid hard applications of
the tractor brakes when towing heavy loads at road
speeds. Never tow the implement at speeds
greater than 20 MPH (32 kph). OPS-U- 0018