Filter
Top Products
Part 7
either in the top cover opening operation after pressing the 2 springs or by
leaving or spilling any improper materials inside after the opening operation.
POWER ADAPTOR
The power connector resides in the lower left
corner of main connector area. Please make sure that
the cable from the power adaptor is inserted into the
power connector of PB system in the correct orientation
as illustrated in right drawing. The manufacturer is not
responsible for any damage caused by improper
orientation of this connection. Please check that for
straight type power plug the arrow mark on the plug is
at top side of the plug. For right angled power plug, if
the arrow mark is on its end, it should be pointing up. If
the arrow mark is on one side of the right angled power
plug, it should be on the right as in the drawing. Please
also check that the city power supply specification from the wall socket is
within the operation range of the power adaptor.
UPS BATTERY (OPTION)
When the PB system is installed with the UPS battery, the UPS
battery is in the carton at delivery. Please take it out and place it in the battery
compartment at center upper part of the connection area indicated as upper
rectangle in picture at right. Connect the cable
to its connector in the main connection area
beside the power connector only when the
system is about to power up for operation.
Always disconnect the UPS battery when the
system is to be left powered off for more than
few days. Please pay particular attention to the
environment requirement for UPS battery in
next chapter “USING THE PB SYSTEM”.
SIDE MOUNT UPGRADE KIT (OPTION TO TM/LM-7112)
When a side-mount upgrade kit option SD-300 or BC-300 is ordered
with the optional TM/LM-7112 LCD panel, this option is already installed in
the delivery. If they were to be later installed or if the side mount upgrade kit is
KP-210, they have to be mounted to the right edge of LCD display at the 2
screws. Then connect the USB cable (If KP-210 is without the smart card
reader, there could be no USB cable.) to the USB port of the PB system and
connect the PS/2 cable of KP-210 to PS/2 KB port of the PB system.
UPS Battery Compartment
UPS Battery Connector