Filter
Top Products
Part 12
appears, please replace the used up UPS battery at power off as soon as
possible.
Emergency treatment:
The battery is constructed maintenance free and leakproof. Its storage
space in PB system also provides very good protection as long as the ambient
temperature remains below 30°C and the ventilation of the PB system remains
free. However, should any accident happen and the sulfuric acid from the
battery spills on skin or clothing, wash immediately with water. If the acid
comes in contact with eyes, rinse eyes with large amount of clean water and
see a doctor immediately. A larger external battery may be connected to give
an extended operation. Please check your dealer about this capability when
required.
WARNING:
If there are any signs of over charging or leakage of electrolyte
please contact your dealer immediately
VGA Display Port
The VGA port in the PB terminal can support a 12 volt DC power to
the external monitor through the VGA signal cable. This may cause permanent
damage to any other monitor not designed to use this facility. Please use only a
Posiflex monitor designed for the PB system when the 12 volt DC power is
supported. Consult your dealer if you have any doubt.
(Note: 12 volt DC power is available on pin 9 of the VGA connector and
is supported by the UPS function if the UPS function module option with UPS
battery is installed.)
The video memory of this port shares from the system memory. The
video memory size can be set in the BIOS CMOS setting to match the user’s
application.
Serial Port – COM1
For the PB system with the UPS function, a COM1 terminator will
also be supplied. Please always occupy COM1 serial port by a suitable serial
device or this terminator. If this port is left vacant or connected with something
like a mouse, the power switch management and the cash drawer control may
fail to work correctly. An RS232 MODEM is not applicable to this port. It is
recommended to use COM2.