Agri-Fab 45-03622 Lawn Mower User Manual


  Open as PDF
of 28
 
8
ASSEMBLY
INSTALL TOWBAR TUBE TO REAR
QUADRANT
• PlaceTowbarTubeintoRearQuadrant,alignholesand
insert3/8x2-3/4HexBoltthroughquadrantandrear
hole of Tube.
• Securetightlywith3/8HexLockNutandthenloosen
1/4turntoallowTubetopivotfreelyinsideRear
Quadrant.
• Insert3/8X2-3/4Boltand3/8FlatWasherintoslotin
Rear Quadrant and into hole in Towbar Tube.
• SecureTightlywith3/8FlatWasherand3/8HexLock
Nut,thenloosen1/4turntoallowTubetopivotfreely
inside Rear Quadrant.
NOTE: Towbar Tube must pivot freely inside Rear Quadrant
when Latch is pulled from notch.
INSTALL CLUTCH CABLE TO TOWBAR TUBE
• PlaceClutchCableforwardalongTowbarTube.
• SpreadendsoftwoCableClipsandplacearound
Clutch Cable.
• PlaceClutchCableontopofTowbarTubeandalign
Cable Clips with bolt holes in Towbar Tube.
• Securewithtwo#10Screws.
INSTALL BATTERY
YourTrailMowerrequiresa12voltbatterytooperate.The
battery is NOT included with the unit. It must be purchased
separately.
• RemovefourscrewsandtheBatteryCoverfromthe
Mowerandsetthemaside.
• InstalltwoPlasticNutsintothesquareholesinthe
MowerDeckundertheBatteryCover.
• PlacetheBatteryontheMowerDeckbetweenthetwo
PlasticNuts.
• PlacetheBatteryHoldDownontopoftheBattery.
• SecuretheBatterytotheMowerDeckwithtwo
1/4x7-1/2hexbolts.
• OpentheterminalaccessdoorsontheBatteryHold
Down.
• ConnecttheRedWiretothepositive(+)batteryterminal
usinga1/4x3/4hexboltand1/4SEMSnut.Tighten
securely.
• ConnecttheBlackWiretothenegative(-)battery
terminalusinga1/4x3/4hexboltand1/4SEMSnut.
Tighten securely.
• Closetheterminalaccessdoors.
• ReplaceBatteryCoverandsecureitwiththefour
screws.
INSTALL CLUTCH CABLE TO CLUTCH LEVER
• Removeouter5/16NutfromendofClutchCable
Housing.(SeeFig.1)
• Turninner5/16Nuttobottomofthread.
• InsertCableandouter5/16Nutthroughslottedhole
in Cable Guide of Hitch Assembly. The outer 5/16 Nut
musts be cocked sideways to insert through slotted hole
of Cable Guide.
• Reinstallouter5/16Nuttothecablehousingtosecure
Cable Harness to Cable Guide.
• InstallMountingAnchorofClutchCabletoClutchLever
usingClevisPinandHairCotterPin.
 previous next