Agri-Fab 45-03622 Lawn Mower User Manual


  Open as PDF
of 28
 
19
CUSTOMER RESPONSIBILITIES
CLUTCH CABLE ADJUSTMENT
• RemovefourscrewsfromRearDriveCover.Layaside
cover and screws.
• PlaceClutchLeverin“DISENGAGED"position
• TheCableshouldbeunderslighttensionbutshould
not pull the Clutch Lever more than 1/8" away from the
Switch Body.
NOTE:IfthePlungerextendsmorethan1/8"outfrom
the switch body, the cable tension is too tight and the
Engine will not start.
TO INCREASE CABLE TENSION
• PlaceBladeClutchLeverinthe“DISENGAGED"
position.
• LoosentheinnernutontheClutchCable.
• TightentheouternutontheClutchCable.
TO DECREASE CABLE TENSION
• PlaceBladeClutchLeverinthe“DISENGAGED"
position.
• LoosentheouternutontheClutchCable.
• TightentheinnernutontheClutchCable.
• Repeattheaboveprocedureuntilyouhavethecorrect
tension.
INNER NUT
OUTER NUT
SWITCH
BODY
CLUTCH LEVER
1/8"
ENGINE
PULLEY
BLADE
PULLEY
IDLER
PULLEY
CLUTCH LEVER
PLUNGER
REAR DRIVE
COVER
FOUR
SCREWS
 previous next