Agri-Fab 45-0346 Lawn Aerator User Manual


  Open as PDF
of 20
 
6
6. Pivot the end plate on your right side up onto the end
oftheaxle.Seegure4.
7. Pivot the end plate on your left side down out of the way.
Seegure4.
FIGURE 4 REAR VIEW
FIGURE 5 REAR VIEW
8. Assemble the following parts in sequence onto the long
endoftheaxle(asshowningure5):
a. Aatwasher(H)andtwoshortspacers(N).
b. A disk hub (L reversed), spike disk and long
spacer (M).
c. A spike disk, disk hub (L), long spacer (M) and
short spacer (N).
d. A spike disk, disk hub (L) and long spacer (M).
e. A spike disk, disk hub (L), long spacer (M) and
short spacer (N).
f. A spike disk, disk hub (L), long spacer (M) and
short spacer (N).
g. A spike disk, disk hub (L) and short spacer (N).
FIGURE 6 REAR VIEW
9. Pivot the end plate up onto the end of the axle. See
gure6.
10. Assembleaatwasher(s)(H)andacotterpin(K)to
one end of the axle. Use as many washers as needed
to eliminate any gaps between the parts on that end of
theaxle.Seegure6.
11. Repeat the procedure for the other end of the axle. See
gure6.
FIGURE 7 REAR VIEW
HINT: Tip the tray over onto it's side for the following
instructions.
12. Assemble four 5/16" x 1" hex bolts (D) and 5/16" nylock
nuts (G) to the holes that were left empty at each corner
of the tray. Tighten alleightcornerbolts.Seegure7.
13. Square up the axle support bracket with the tray. Tighten
thefourboltsandnutsassembledingure1thatfasten
the axle support bracket and lift plate to the center of
the tray.
(N) SHORT
SPACER
(M) LONG
SPACER
SPIKE
DISK
(L) DISK HUB
REVERSED
(H) FLAT
WASHER
(L) DISK HUB
1
2
(H) FLAT WASHER
(K) COTTER PIN
(H) FLAT WASHER
(K) COTTER PIN
(G) 5/16" NYLOCK NUT
(D) 5/16" x 1"
HEX BOLT
TIGHTEN (4) NUTS
ENGLISH
 previous next