Agri-Fab 45-0346 Lawn Aerator User Manual


  Open as PDF
of 20
 
5
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(2) 1/2" wrenches
(1) 9/16" wrenches
(1) 3/4" wrench or adjustable wrench
Before assembling the aerator, lay out all of the parts and
hardware as shown on the previous pages.
FIGURE 1 FRONT VIEW
FIGURE 2 REAR VIEW
1. Assemble the end plates to the inside slots at each end
of the tray using two 5/16" x 1" hex bolts (D) and 5/16"
nylock nuts (G) per end plate. Do not tighten yet. See
gure1.
2. Assemble the lift plate (P) and the axle support bracket
to the tray using four 5/16" x 1" hex bolts (D) and 5/16"
nylock nuts (G). Do not tighten yet.Seegure1.
(D) 5/16" x 1"
HEX BOLT
(G) 5/16" NYLOCK NUT
(D) 5/16" x 1"
HEX BOLT
(P) LIFT PLATE
AXLE
SUPPORT
BRACKET
3. Turnthetrayupsidedownasshowningure2sothat
the rear of the tray (four holes in the bottom) is facing
you. Assemble two hitch arm mount brackets and two
angle brackets (O) to the bottom of the tray using four
5/16" x 1" hex bolts (D) and 5/16" nylock nuts (G). Do
not tighten completely.Seegure2.
FIGURE 3 REAR VIEW
4. Pivot the end plate on your right side down out of the
way. Place the long end of the axle, measured from the
middle blind hole, through the pivot plate on your left
side. (If there are two middle holes, use the hole that is
in alignment with the end holes.) Fit the middle hole in
the axle down onto the tab on the axle support bracket.
Seegure3.
5. Assemble the following parts in sequence onto the short
endoftheaxle(asshowningure3):
a. Aatwasher(H),shortspacer(N),diskhub(L)
and spike disk
b. A long spacer (M), disk hub (L) and spike disk.
c. A long spacer (M), disk hub (L) and spike disk.
d. A long spacer (M), disk hub (L) and spike disk.
e. A long spacer (M), disk hub (L) and spike disk.
f. Two short spacers (N), a disk hub (L) and spike disk.
g. A short spacer (N).
Spike points are sharp. Exercise caution when
handling and working near spike disks.
HITCH ARM
MOUNT
BRACKET
(G) 5/16" NYLOCK NUT
(D) 5/16" x 1"
HEX BOLT
(O) ANGLE
BRACKET
ENGLISH
AXLE SUPPORT
BRACKET
(N) SHORT
SPACER
(M) LONG
SPACER
SPIKE
DISK
(L) DISK
HUB
(H) FLAT
WASHER
SHORT END
LONG END
TAB
HOLE
(N) SHORT
SPACER
 previous next