Agri-Fab 45-03011 Spreader User Manual


  Open as PDF
of 12
 
5
FIGURE 6
PLASTIC
KNOB
NYLON
WASHER
1/4" x 3/4"
CARRIAGE BOLT
FLOW
CONTROL
GAUGE
14.Assembletheowcontrolgaugetothehopperbrace
usingthe1/4"x3/4"carriagebolt,anylonwasherand
theplasticknob.Seegure6.
NOTE: Thewheelsmaybetemporarilyremovedforeasier
access when assembling the tongue braces in the
followinginstructions.
10.Insertatonguebracethroughtheslotintheendplate.
Fastenthefrontholeofthetonguebracetotheendplate
usinga1/4"x5/8"hexboltand1/4"hexnut.Fortherear
holeusea1/4"x3/4"hexbolt,1/4"atwasherand1/4"
hexnut,withtheboltandwasherassembledfrominside
thepolyhopper.Seegure5.Do not tighten yet.
11.Fastentheotherendofthetonguebracetothesideof
thetongueusingtwo1/4"x5/8"hexboltsand1/4"hex
nuts.Do not tighten yet.Seegure5.
12.Repeatsteps10and11forthesecondtonguebrace.
13.Tightenallboltsandnutsassembledsofar.
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK
NUT
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK NUT
1/4" x 3/4"
HEX BOLT
1/4" FLAT
WASHER
WHEEL REMOVED
FOR ACCESS
FIGURE 5
15.Checkthatbothferrulesareadjustedsothatapproximately
tenthreads(1/2")ofthecontrolrodisexposed.Insert
bothferrulesintothebracketswhicharerivetedtothe
frontoftheowplates.Assemblea1/4"hexlocknut
ontoeachferrule,makingonlynger tightatthistime.
Seegure7.
1/4" NYLOCK NUT
BRACKET
FERRULE
FIGURE 7
 previous next