Agri-Fab 45-0364 Spreader User Manual


  Open as PDF
of 12
 
7
24. Positiontheowcontrolmountingbracket(gure12).
a. Pushon owcontrol arm untilit locks in"OFF"
position.
b. Slideowcontrolmountingbracketalongtubeuntil
closure plate in bottom of hopper just closes.
c. Snugthe5/16"locknutsjustenoughtoholdow
control mounting bracket in place.
d. Setadjustablestopat "5".Pull owcontrol arm
against stop. Verify that closure plate has opened
about half way.
e. If closure plate does not open half way, adjust
position of ow control mounting bracket until
closure plate will open about half way at "5" and
will still close when arm is locked in "OFF" position.
Tighten the 5/16" lock nuts.
FIGURE 12
27. For most vehicles, assemble the hitch extension bracket
to the holes in the hitch tube shown at the topofgure
14. Use two 1/4" x 1-3/4" hex bolts (B) and 1/4" hex lock
nuts(F)tightenedonlyngertight.Attachthespreader
hitch to your vehicle hitch. Check for interference with
the spreader directly behind and out to both sides of
the vehicle. Lift the spreader at each position to make
surethereisnointerferencewiththespreader'sow
control. If there is interference with the rear of the vehicle,
assemble the hitch extension bracket as shown at the
bottomofgure
14. Tightentheboltsandnutswhennished.
FIGURE 11
FLOW
CONTROL
ARM
OFF
ON
1
2
3
4
6
7
8
9
10
5
ADJUSTABLE
STOP (S)
(SETTING "5")
ON
OFF
(Q) NYLON
WING NUT
OFF
ON
1
2
3
4
6
7
8
9
10
5
(J) 5/16" FLAT
WASHER
(I) NYLON
WASHER
(R) ADJUSTABLE
STOP
(E) 1/4" x 3/4"
CARRIAGE BOLT
FIGURE 14
25. Assemble the hitch bracket to the hitch extension bracket
using two 3/8" x 3/4" hex bolts (C) and 3/8" hex lock nuts
(H).Inserttheboltsfromthebottom.Seegure13.
26. Assemble the hitch pin (O) through the hitch bracket
and the hitch extension bracket and secure with the
haircotterpin(N).Seegure13.
(F) 1/4" HEX
LOCK NUT
(B) 1/4" x 1-3/4"
HEX BOLT
FIGURE 13
(C) 3/8" x 3/4"
HEX BOLT
(H) 3/8" HEX
LOCK NUT
(O) HITCH PIN
(N) 1/8" HAIR
COTTER PIN
 previous next