Agri-Fab 45-0364 Spreader User Manual


  Open as PDF
of 12
 
6
22. Placea5/16"atwasher(J)ontotheotherendofthe
owcontrolrod.Inserttheendoftherodthroughthe
curvedslotintheowcontrolmountingbracketand
throughtheholeintheowcontrollink.Securewitha
5/16"atwasher(J)anda3/32"x3/4"cotterpin(L).
Seegure10.
NOTE: You can leave off the second washer if there is not
enough room on the end of the rod.
21. Hookthedoublebentendoftheowcontrolrodthrough
the hole in the slide gate bracket located near the bottom
ofthehopper.Seegure9.
FIGURE 9
FIGURE 8
20. Assemble the ow control arm to the ow control
mounting bracket using a 1/4" x 3/4" hex bolt (D), two
nylon washers (I) and a 1/4" hex lock nut (F). Tighten
carefully. The ow control arm should be snug but
should pivot with no more than slight resistance. See
gure8.
18. Assemblethevinylgrip(T)ontotheowcontrolarm.
Seegure7.
19. Inserttheowcontrolarmdownthroughtheslotinthe
owcontrolbracket.Assemblethesmallholeoftheow
controllink(U)totheowcontrolarmusinga1/4"x1"
hex bolt (D), a nylon washer (I) and a 1/4" hex lock nut
(F)asshowningure7.Tighten carefully. Theow
control link should be snug but should pivot with no
more than slight resistance.
23. Place the adjustable stop (R) into the "ON" end of the slot
inthetopoftheowcontrolmountingbracket.Secure
with the 1/4" x 3/4" carriage bolt (E), a nylon washer (I),
a5/16"atwasher(J)andthenylonwingnut(Q).See
gure11.
FIGURE 10
FIGURE 7
(B) 1/4" x 1"
HEX BOLT
(F) 1/4" HEX
LOCK NUT
OFF
ON
1
2
3
4
6
7
8
9
10
5
(U) FLOW
CONTROL
LINK
(small hole)
(I) NYLON
WASHER
(T) VINYL GRIP
OFF
ON
1
2
3
4
6
7
8
9
10
5
(B) 1/4" x 3/4"
HEX BOLT
(F) 1/4" HEX
LOCK NUT
(I) NYLON
WASHERS (2)
FLOW
CONTROL
ROD
OFF
ON
1
2
3
4
6
7
8
9
10
5
(J) 5/16"
FLAT
WASHER
(L) 3/32"
COTTER PIN
(J) 5/16"
FLAT
WASHER
 previous next