Agri-Fab 45-0364 Spreader User Manual


  Open as PDF
of 12
 
5
FIGURE 4
12. Turn the spreader upright on its wheels.
13. Assembletheowcontrolmountingtubetothehitch
tube using two 5/16" x 1-3/4" hex bolts (A) and 5/16"
hex lock nuts(G). DO NOT TIGHTEN YET.Seegure
5.
14. Assemblethevinylcap(S)ontotheowcontrolmounting
tube.Seegure5.
FIGURE 5
9. Assembleaspacer(P),a3/4"atwasher(K),awheel
(airvalvefacingout)andanother3/4"atwasher(K)
onto the end of the axle that has both the large and
small holes.Seegure4.
10. Install a 1/8" x 1-1/2" cotter pin (M) into the small hole
intheendoftheaxle.Seegure4.
11. Open the bail on the drive pin (V) and install it through
the wheel and the large hole in the axle. Close the bail
tolockthepininplace.Seegure4.
FIGURE 6
15. Assembletheowcontrolmountingbracketandthetube
supportstraptotheowcontrolmountingtubeusing
two 5/16" x 1-3/4" hex bolts (A), four 5/16" washers (J)
and two 5/16" hex lock nuts (G). DO NOT TIGHTEN
YET.Seegure6.
16. Remove the preassembled bolt and nut from the front of
the hopper. Attach the tube support strap to the hopper
and hopper strap using the bolt and nut you removed.
TIGHTEN thenutandbolt.Seegure6.
(G) 5/16" HEX
LOCK NUT
(A) 5/16" x 1-3/4"
HEX BOLT
(J) 5/16"
FLAT WASHER
PREASSEMBLED
BOLT AND NUT
TUBE
SUPPORT
STRAP
HOPPER
STRAP
OFF
ON
1
2
3
4
6
7
8
9
10
5
(V) DRIVE PIN
AIR VALVE
(P) SPACER
(K) 3/4" DIA.
FLAT WASHER
(M) 1/8" x 1-1/2"
COTTER PIN
(A) 5/16" x 1-3/4"
HEX BOLT
(G) 5/16"HEX
LOCK NUT
(S) VINYL CAP
17. TIGHTEN thetwoboltswhichfastentheowcontrol
mounting tube to the hitch tube. DO NOT TIGHTEN the
twoboltswhichfastentheowcontrolmountingbracket
totheowcontrolmountingtube.
 previous next