Filter
Top Products
11
25. Assemble a short tarp strap to rear door using one 1/4" x
1-1/4" hex bolt, two 1/4" at washers and one 1/4" Nylock
hex nut. Assemble an "S" hook through loose end of
strap. See gure 15. Repeat on other side of door.
26. Assemble door to rear of cart by resting bottom of door
on door supports and pushing top of door in against
cross brace. Secure top of door using door latches on
each side. See gure 15.
27. Hook both the tarp straps onto the 1/4" x 1" hex bolts in
the sides of the cart. See gure 15.
FIGURE 16
FIGURE 15
5/16"
NYLOCK
NUT
5/16" x 3/4"
HEX BOLT
WELDED
ANGLES
FRONT
TONGUE
5/16" FLAT
WASHER
FIGURE 17
Center elbow between
sides of opening
Loosen (4) bolts
1/4 turn each
5/16" x 3/4"
HEX BOLT
(Thread Forming)
NYLON
WASHER
1/4" x 1-1/4" HEX BOLT
1/4" FLAT WASHER
1/4" NYLOCK
HEX NUT
TARP STRAP (SHORT)
DOOR
SUPPORTS
DOOR LATCH
1/4" FLAT
WASHER
"S" HOOK
1/4" x 1"
HEX BOLT
28. Attach the engine/impeller housing assembly to the
upper slots in the angles welded to the tongue. Use
four 5/16" x 3/4" hex bolts, 5/16" at washers and 5/16"
nylock nuts. Washers go between bolt heads and slots
in welded angles. Tighten. See gure 16.
29. Assemble the elbow to the impeller housing using
four 5/16" x 3/4" self tapping hex bolts and four nylon
washers. Push while turning to help start the bolts into
the unthreaded holes. Tighten. See gure 17.
30. To center the elbow with the opening in the hard top:
a. Push the vinyl boot back inside the opening.
b. Loosen by approximately 1/2 turn each, the four
bolts that you assembled in gure 16.
c. Slide the engine in the slots until the elbow is
centered with the opening in the hardtop.
d. Retighten the four bolts that you loosened.
31. Pull the vinyl boot onto the end of the elbow.