Filter
Top Products
10
FIGURE 11
20. Place a side panel on top of the cart bed ange, inside
the lip of the front panel. Fasten the side panel to the front
panel using three 1/4" x 5/8" hex bolts and 1/4" Nylock
hex nuts. Fasten the side panel to the cart bed ange
using two 1/4" x 5/8" hex bolts, 1/4" at washers, and
1/4" Nylock hex nuts. Tighten.See gure 11. Repeat on
other side.
FIGURE 12
21. Screw a 1/4" Nylock hex nut approximately half an inch
onto a 1/4" x 1" hex bolt. Insert the bolt into the hole
shown in gure 12, in the side of the cart. Fasten the
bolt to the cart using a 1/4" Nylock hex nut. Tightenso
that the nut is ush with the end of the bolt. Repeat on
the other side. See gure 12.
22. Assemble the cross brace to the top rear holes in the
side panels using four 1/4" x 5/8" hex bolts and 1/4"
Nylock hex nuts. See gure 12.
23. Assemble a door latch at each end of the cross brace
using a 5/16" x 3/4" hex bolt, a nylon washer and a
5/16" Nylock hex nut. Place the nylon washer between
the door latch and cross brace. Tighten so that latch is
snug but will still rotate. See gure 13.
FIGURE 13
5/16" x 3/4"
HEX BOLT
CROSS
BRACE
DOOR
LATCH
NYLON
WASHER
5/16" NYLOCK
HEX NUT
24. Install the poly hard top using fourteen 1/4" x 3/4" hex
bolts and 1/4" at washers on the outside and fourteen
1/4" at washers and 1/4" Nylock hex nuts on the inside.
Tighten. See gure 14.
FIGURE 14
1/4" x 5/8"
HEX BOLT
1/4" NYLOCK
HEX NUT
1/4" NYLOCK
HEX NUT
1/4" x 5/8"
HEX BOLT
1/4" FLAT WASHER
1/4" x 3/4"
HEX BOLT
1/4" FLAT
WASHER
1/4" NYLOCK
HEX NUT
POLY HARD TOP
1/4" FLAT
WASHER
1/4" NYLOCK
HEX NUT
1/4" NYLOCK
HEX NUT
1/4" x 5/8"
HEX BOLT
CROSS
BRACE
1/4" NYLOCK
HEX NUT
1/4" x 1"
HEX BOLT