Filter
Top Products
6
4. Mounting the Sensor
The sensor can be mounted on the following types of surfaces:
• Wall, ceiling, or electrical box (NEMA enclosure)
• Tabletop
Wall, Ceiling, or Electrical Box Mounting
Use the included mounting bracket to install the sensor on a wall, ceiling, or electrical box.
To wall-mount the sensor:
1 Route Ethernet cable through the opening in the cradle.
2 Screw the mounting bracket to a wall, ceiling, or electrical box (NEMA enclosure):
• If mounting to a solid surface wall or ceiling, use the two sheet metal screws.
• If mounting to drywall, use the two sheet metal screws and two wall anchors.
• If mounting to an electrical box (NEMA enclosure), use the two threaded screws.
The figures below show a cable being routed through the large opening in the cradle and
then the cradle being mounted to a wall.
3 Connect the Ethernet cable (for power and network connection) to the port on the rear of
the sensor.
4 Twist the sensor onto the mounting bracket.
Tabletop Mounting
To install the sensor on a flat surface such as a table or desktop:
1 Remove the backing from the four rubber feet and attach them on the bottom of the sensor.
2 Place the sensor on the table.
3 Connect the Ethernet cable (for power and network connection) to the port on the rear of
the sensor.
Wall-mounting the cradleRouting a cable