Chapter 6 Administration
NWA1300-NJ User’s Guide
48
6.3 FTP
You can use FTP (File Transfer Protocol) to upload and download the NWA1300-
NJ’s firmware and configuration files, see Section 6.4 on page 49 and Section 6.5
on page 53 for details. To use this feature, your computer must have an FTP
client.
Start Date Select the month and day that your daylight-savings time starts on if
you selected Daylight Saving Time.
End Date Select the month and day that your daylight-savings time ends on if
you selected Daylight Saving Time.
LED Setting Select Enable to have the LEDs on the front panel operate as long as
the NWA1300-NJ is powered on.
Select Disable to have the LEDs on the front panel operate during
start-up and turn off once the NWA1300-NJ is ready.
Secure
Administrator IP
Address
Select Any to use any computer to access the web configurator on the
NWA1300-NJ.
Select Specify and then enter the IP address(es) or ranges of IP
addresses of the computer(s) that are allowed to log in to configure
the NWA1300-NJ. The addresses can be on the LAN or the WAN.
Allow remote
user to ping the
device
Ping (Packet INternet Groper) is a protocol that sends out ICMP echo
requests to test whether or not a remote host is reachable. Select
Enable to have the NWA1300-NJ respond to incoming Ping requests
from the WAN. This is less secure since someone on the Internet can
see that the NWA1300-NJ is there by pinging it.
Select Disable to have the NWA1300-NJ not respond to incoming Ping
requests from the WAN. This is more secure since someone on the
Internet cannot see that the NWA1300-NJ is there by pinging it.
Apply Click Apply to save your changes back to the NWA1300-NJ.
Table 9 ADMINISTRATION > MANAGEMENT (continued)
LABEL DESCRIPTION
