ZOOM 707II GUITAR
36
COLOR
1 – 4
Selects sound character.
Periodically varies the level of the sound.
DEPTH
0 – 10
Adjusts modulation intensity.
RATE
1 – 30
Adjusts modulation speed.
CLIP
0 – 10
Adjusts modulation waveform clip. Larger values result
in more intense modulation.
This stereo panning effect periodically moves the sound
back and forth between right and left when two
amplifiers are used. When one amplifier is used, the
effect is a tremolo effect.
WIDTH
0 – 10
Adjusts effect width.
RATE
1 – 30
Adjusts modulation speed.
CLIP
0 – 10
Adjusts modulation waveform clip. Larger values result
in more intense modulation.
This effect gives a varying wah sound that depends on
the picking intensity.
POSI
AF, bF
Selects connection point of MOD module.
• AF: After CABINET module
• bF Before DRIVE module
RESO
1 – 10
Adjusts wah effect intensity
SENS
-10 – -1, 1 – 10
Adjusts sensitivity. Negative values result in downward
wah.
This effect lets you control wah with the expression pedal.
POSI
AF, bF
Selects connection point of MOD module.
• AF: After CABINET module
• bF Before DRIVE module
FREQ
1 – 10
Adjusts wah effect center frequency.
DIRMIX
0 – 10
Adjusts direct sound mix.
This is a special effect with step-like filter characteristics.
DEPTH
0 – 10
Adjusts modulation intensity.
RATE
1 – 30
Adjusts modulation speed.
RESO
0 – 10
Adjusts wah effect intensity.
This is a pitch shifter with a range of 2 octave up and 1
octaves down.
SHIFT
-12 – 1, dt, 1 – 12, 24
Sets the pitch shift amount. The "dt" setting results in a
detune effect.
TONE
0 – 10
Adjusts effect tone.
BAL
0 – 30
Adjusts balance between direct sound and effect sound.
Higher values emphasize effect sound.
This effect lets you vary the pitch in real time, using the
expression pedal.
TYPE
1 – 16
Selects the pedal pitch type. Depending on the type, the
pitch differs when pushing the pedal down or when
raising it.
TONE
0 – 10
Adjusts effect tone.
Produces a metallic sound.
POSI
AF, bF
Selects connection point of MOD module.
• AF: After CABINET module
• bF Before DRIVE module
RATE
1 – 30
Sets frequency for ring modulation effect.
The tone changes depending on the frequency setting.
BAL
0 – 30
Adjusts balance between direct sound and effect sound.
This effect automatically creates a "violin playing"
sound.
POSI
AF, bF
Selects connection point of MOD module.
• AF: After CABINET module
• bF Before DRIVE module
TIME
1 – 30
Adjusts attack speed.
CURVE
1 – 10
Adjusts attack curve.
Parameter 3
Parameter 2
Parameter 1
SLOW-A (Slow Attack)
TYPE 13
Parameter 3
Parameter 2
Parameter 1
RING M (Ring Modulator)
TYPE 12
Parameter 2
