Storing Rhythm Patterns and Samples as Part of a Patch
26
By assigning rhythm patterns to patches, you
can have the rhythm change in sync with the
patches.
1.
In play mode, select the patch to
which you want to assign a rhythm
pattern, and press the [EDIT] key.
2.
Use the MODULE [
E
]/[
R
] keys to
select the TOTAL module.
3.
Press the [EDIT] key once more.
The [EDIT] key lights up in green. You can
now use parameter knob 1 to select the rhythm
pattern to assign to the patch.
4.
Use parameter knob 1 to select the
desired rhythm pattern.
The pattern name appears on the display. You
can play the pattern by pressing the [R/P] key.
Depending on the rhythm pattern type selected
here (intro, ending, other), the pattern playback
operation when switching patches will differ.
5.
Press the [STORE/EXECUTE] key to
store the patch.
Assign other rhythm patterns to other patches in
the same way.
6.
When all patches have been prepared,
press the [PATCH SYNC] key so that
the LED of the key is lit.
When the [PATCH SYNC] key is set to ON,
patches and rhythm patterns are switched in
sync.
When the [PATCH SYNC] key is set to OFF, the
rhythm pattern assignment to the patches has no
effect.
7.
Call up the patch to which the desired
rhythm pattern was assigned.
When the [PATCH SYNC] key is set to ON, the
operation when switching patches depends on
the type of rhythm pattern that has been
assigned.
●
Intro rhythm pattern (INTRO 1 – 9)
When a patch is switched, rhythm pattern play
starts automatically. The pattern continues to
play until the [
R
/
P
] key is pressed or until you
switch to another patch.
●
Ending rhythm pattern (ENDING 1 – 6)
After switching a patch, rhythm pattern play
begins if you press the [
R
/
P
] key. The pattern
automatically stops at the end of the pattern.
●
Other rhythm pattern
After switching a patch, rhythm pattern play
begins if you press the [
R
/
P
] key. The pattern
continues to play until the [
R
/
P
]key is pressed
again or until you switch to another patch.
