Using and replacing the light
bulbs
The woktop light
The fluorescent light is on the bottom of the
contro! panel. The Cimktop Lght Switch is
located on the left side of the front control panel.
ElectrIcal Shock and Burn Hazard
Make iwre power to the range has been
dlswnnected at the maln power supply
and that all surface burners are OFF and
cool. Fallure to do so could result In
elect&al shock or burns.
To replace the woktop light:
1. Turn off the control knobs and unplug
appliance or disconnect at the main power
supply.
2. Lii up the cooktop and disconnect the
electrical plug to the backguard. Lower the
cooktop.
3. Grasp each side of the backguard and lift it
straight up.
4. Turn backguard over. Remove the four
screws holding the back cover panel, then
remove the cover.
5. Roll bottom of fluorescent tube away from
you until both ends can be removed from the
receptacles. Replace with a 20-watt cool-
white fluorescent tube.
6. Replace the back cover panel and screws.
7. Replace the backguard. Reconnect the
electrical plug under the cooktop.
8. Plug in appliance or reconnect at the main
power supply.
19
