6
Windows 95 and Windows 98: PhaserPort Software
34
PhaserShare Networking
e.
If desired, change the printer’s name (the name that will show in
your Printers window). You can also choose to make this printer
your default Windows printer. Click Next.
f.
If you are prompted to send a test page to the printer, choose No.
Click Finish.
5.
Complete the installation.
a.
In the Installation Completed dialog, click Finish.
b.
When prompted, finish the setup by registering your printer and
restarting your computer.
6.
The following topics provide instructions for using PhaserPort after the
initial installation:
■ The next topic: “Adding a port for a new printer”.
■ “Adding a port to an existing printer” on page 35.
■ “Changing a port’s IP address” on page 36.
Adding a port for a new printer
Use this procedure to install a new printer and add a port for it.
1.
Start the Add Printer Wizard:
a.
From the Start menu, select Settings, then click Printers.
b.
From the Printers window, open Add Printer.
2.
Use the Add Printer Wizard to install the printer. When prompted,
make the following choices:
■ When prompted to specify how the printer is attached, choose
Local Printer.
■ Choose LPT1 as the connection port.
3.
When you are finished with Add Printer Wizard, follow the directions
in the next topic, “Adding a port to an existing printer”.
If you are prompted to send a test page to the printer, choose No.
