4
Novell NetWare Configuration
24
PhaserShare Networking
Verify information and finish the configuration
After you have entered the configuration information, the Quick Configuration
Wizard displays the Configured Printer Information dialog box, which reports
the information you have entered.
1.
Verify that the information is correct.
■ If the information is correct, click Apply Changes.
■ If the information is not correct, click Back to return to previous
dialog boxes and correct the information. Click Next to return to
the Configured Printer Information dialog box. Click Apply
Changes.
■ To exit the wizard and return to the Main window without making
any changes, click Cancel.
2.
After you click Apply Changes, the printer resets; the changes take
effect when the reset is complete.
3.
After the reset, you are prompted to print a test page. It is
recommended that you print a test page to verify a successful
installation. For more information on NetWare configuration and
troubleshooting, see the PhaserShare Networking Manual on your
printer’s CD-ROM.
Setting IPX frame types from the front panel
1.
When the front panel displays READY TO PRINT, press the
down-arrow button until Menu is highlighted. Press Select.
2.
Press the down-arrow button until Printer Configuration is
highlighted. Press Select.
3.
Press the down-arrow button until Network Settings is
highlighted. Press Select.
4.
Press the down-arrow button until NetWare is highlighted. Press Select.
5.
Press the down-arrow button until IPX Frame Type is highlighted.
Press Select.
6.
Press the down-arrow button until the desired frame type is
highlighted. Press Select until On is displayed. If desired, you can set
more than one frame type.
7.
To return the printer to normal operation, press the down-arrow button
until Exit is highlighted. Press Select.
