A SERVICE OF

logo

22
Instructions for assembly
GB
Working surface cut-out
Cut out the worktop recess accurately with a
good, straight saw blade or recessing
machine. The cut edges should then be sealed
so that no moisture can penetrate. The area is
cut out as illustrated.
The glass ceramic hob must have a level and
flush bearing. Any distortion may lead to
fracture of the glass panel.
Make sure that the sealing of the hob is
properly seated.
The glass ceramic hob is fastened with clips or
with brackets.
Clips
Drive the clips into the worktop cut-out at the
intervals indicated.
It is not necessary to adjust the height due
to the horizontal stop motion device.
Important! The horizontal drive of the clips
must be flush with the worktop (avoid the
risk of breaks).
Position the hob according to the illustration
on the left side (a), align it (b) and insert the
clips (c).
Screws may be used to fasten the clips.
Brackets
Insert the hob and align it.
From the bottom, insert the brackets with
screws in the holes provided for fastening
the brackets, align the brackets and screw
them tight.
Tighten the screws with a hand screw driver
only; do not use a battery-operated screw
driver.
In the case of thin worktops make sure that
the brackets are correctly positioned. A
metric screw must be used on the bracket to
balance it.
Important!
There is a risk of breakage if the hob is
canted or subjected to stress during instal-
lation!
1
Minimum distance to adjacent walls
2
Cut-out dimension
3
Outer dimensions of the hob
4
Cable routing in rear wall
5
Installation height
Dimensions in mm