A SERVICE OF

logo

Open as PDF
next previous
Auto PC Adjustment function is provided to automatically adjust Fine sync, Total dots, Position H and
Position V to conform to your computer.
To store the adjusted parameters:
The adjusted parameters from the Auto PC Adjustment
can be stored in the projector. Once the parameters are
stored, the setting can be done just by selecting Mode in
PC SYSTEM Menu (p.36). See “Manual PC Adjustment”
on pages 38-39.
The Auto PC adjustment function can be operated directly
by pressing the AUTO PC button on the remote control.
Remote Control
Computer Input
PC adjust Menu
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select PC adjust
and then press the Point ► or the SELECT button.
1
2
Use the Point ▲▼ buttons to select Auto PC adj. and
then press the SELECT button.
Use the Point ▲▼ buttons to
select Auto PC adj. and press the
SELECT button.
Please wait... appears while the
Auto PC adjustment is in process.
Auto PC Adjustment
Direct Operation
Menu Operation
Auto PC adj.
AUTO PC
button
Note:
 •Finesync,Totaldots,PositionHandPositionVof
certaincomputerscannotbefullyadjustedwiththe
AutoPCAdjustmentfunction.Whentheimageis
notprovidedproperlywiththisoperation,manual
adjustmentsarerequired.(pp.38-39)
•TheAutoPCadjustmentcannotbeoperatedwhen
480i,575i,480p,575p,720p,1035i, 1080i or
1080pisselectedinthePCSystemMenu(p.36),or
whenthesignaliscomingfromtheHDMIorDVI-D
terminal.
 •Dependingontheconditionofsignalsandthe
typeandlengthofcables,thesignalsmaynotbe
properlyviewed.
37