51
Setting
Time left before Lamp is off.
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready ............... When the lamp has been fully cooled
down, the POWER indicator changes
to green blinking. In this condition,
the projection lamp will be turned on if
the input signal is reconnected or any
button on the top control or remote
control is pressed.
Shut down ....... When the lamp has been fully cooled
down, the power will be turned off.
Off .................... Power management function is off.
Timer ................ If the input signal is interrupted and
no button is pressed for more than
30 seconds, the timer display with
No signal appears. It starts the
countdown until the lamp is turned off.
Use the Point buttons to set the
Timer(1~30min).
Note:
Factory default is Ready: 5 min.
When this function is set to On, the projector will be automatically
turned on just by connecting the AC power cord to a wall
outlet.
Note:
Be sure to turn off the projector properly (see “Turning
Off the Projector” on page 20). If the projector is turned
off in the incorrect sequence, the On start function does
not work properly.
This function is available when operating the projector via
network.
Network .... Supply the power to the network function even
after turning off the projector. You can turn on/
off the projector via network, modify network
environment, and receive an e-mail about
projector status while the projector is powered
off.
Eco ............ Select Eco when you do not use the projector
via network. The projector’s network function
will stop when turning off the projector.
Refer to the owner’s manual “Network Set-up and Operation”.
Note:
• Factory default is
Network
.
•
When selecting Network, the cooling fans may
be running
depending on the temperature
inside the projector even if the projector is
turned off.
Power management
On start
Standby mode
