41 Beyond the Basics
Storing Frequencies Found During
Chain Search into Channel Memory
You can store frequencies you find in chain search
mode or chain search hold mode.
Press FUNC + PGM in chain search mode or
chain search hold mode. The lowest blank
channel and bank appear.
Press E to store the frequency into the blank
channel. To select another channel, press FUNC
+ or before you press E. To enter the
frequency, press FUNC. disappears. Then
press E. You can also press 0-9 to select the bank.
If you try to save a frequency that is already stored,
the scanner sounds an error tone and displays the
channel that was duplicated. If you entered the
frequency by mistake, press
.
/CLR. To enter the
frequency anyway, press E to accept.
The scanner sets itself to program mode after you
store a frequency.
Program Band Select Mode
You can use this mode to define the search range
used during a chain search in each search bank. To
set the scanner to program band select mode, press
FUNC + B.SLCT. SEARCH appears. Then select a
search bank.
F
20-501.fm Page 41 Friday, July 9, 2004 3:23 PM
