25 Beyond the Basics
operating your scanner
Turning On The Scanner and
Setting Squelch
Your scanner is preprogrammed at the factory with
150 of the most frequently used frequencies in
Channels 1 to 150. You can scan these frequencies
as soon as you turn on the scanner.
Note: Make sure the scanner's antenna is connected
before you turn it on.
Turn SQUELCH fully counterclockwise.
Press and hold for about 2 seconds to turn
the scanner on, then turn VOLUME clockwise
until you hear a hissing sound.
Turn SQUELCH clockwise until the hissing stops.
Press SCAN. See “Scanning the Stored Chan-
nels” on Page 30.
Storing Known Frequencies
Into Channels
You can locate and store specific frequencies into
channels for later use. To assist you in locating a
desired frequency from the scanner's wide range,
consider using a frequency guide.
20-501.fm Page 25 Friday, July 9, 2004 3:23 PM
