Surround sound setup
04
17
En
English
Setting the channel levels while playing a
source
The following way of setting the channel levels is best
done while playing a multichannel source, such as a
DVD. See also the following chapter,
Listening to your
system
on page 18 for more on playing sources.
1 Press CH LEVEL on the remote or CHANNEL LEVEL
on the front panel to select a speaker to adjust.
Each press changes the selected speaker:
•
L
– Left front speaker
•
C
– Center speaker
•
R
– Right front speaker
•
RS
– Right surround speaker
•
LS
– Left surround speaker
•
SW
– Subwoofer
On the right side of the display you can see the current
channel level setting. Initially these are all set at zero.
2 Use the
/
(cursor left/right) buttons to
change the setting for the displayed speaker.
You can adjust each speaker from
–10
(quieter) to
+10
(louder).
• You can also use the front panel
<
and
>
buttons,
although it’s usually best to make this setting from
your listening position using the remote.
3 When you’re done, press ENTER to exit.
If no button is pressed for ten seconds, channel setting is
automatically exited.
CH LEVEL
ENTER
SX-315.book Page 17 Friday, February3, 2006 12:18 PM
