60
■ VMD (Area Setup)
Set the VMD area.
The following window will be displayed when the [SET] but-
ton is pressed after moving the cursor onto "Set".
Green area: Set as the VMD area.
Clear area: Not set as the VMD area.
Red area: Cursor
Light blue area: Set as the VMD area, and currently motion
is being detected.
The VMD area can be set using the following buttons.
Arrows button: Select an area.
[SKIP d]/[SKIP s] buttons: Determine whether or not to
set the selected area as the VMD area (green: set as the
VMD area, clear: not set as the VMD area).
When completing the VMD area setting, press the [ESC]
button.
The "Alarm Rec. Setup" window will be displayed.
Move the cursor onto "OK" and press the [SET] button to
apply the settings.
Default: All areas are set as the VMD area.
Notes:
• The colors of the VMD areas may look not exactly as
described depending on the brightness or contrast of
the images displayed in the areas.
• The VMD area cannot be set for "Alarm No." to which no
video signal is supplied.
■ Advanced Setup
The following window will be displayed when the [SET] but-
ton is pressed after moving the cursor onto "Set→".
Configure the following settings on the setup window of
each "Alarm No." (☞ page 59).
Rec. Duration
Set the alarm recording duration.
000, 030 - 999 (sec)
When "000" is selected, recording will not stop until the
alarm is reset.
Default: 030 (sec)
Alarm Duration
Set the active duration of the alarm action (LED blinking,
buzzer sounding, alarm output from the terminal on the rear
of the recorder).
001 - 999 (Sec)
Default: 030 (Sec)
Alarm Output Port
Select a port from which an alarm signal is output.
0 - 4
When "0" is selected, no alarm signal will be output.
Default: 0
Alarm Spot Camera No.
Select a camera channel from which images are to be dis-
played on a single screen at an event occurrence.
1 - 16
Default: (Same value set for "Alarm No.")
Preset Camera No.
Select a camera channel that the connected camera is to
be moved to the preset position at an alarm occurrence.
1 - 16
Default: (Same value set for "Alarm No.")
Preset Position
Set the preset position to which the camera moves at an
event occurrence.
000 - 256
When "000" is selected, the camera will not move at an
event occurrence.
Default: 000
[All] button
When the [SET] button is pressed after moving the cursor
onto "All", the same settings will be applied to the following
for all of the "Alarm No.".
• Rec. Quality
• Rec. Frame Rate
• Time range of each schedule
• Sensitivity
• Rec. Duration (Advanced Setup)
• Alarm Duration (Advanced Setup)
• Alarm Output Port (Advanced Setup)
No.01 Alarm Rec. Setup(Advanced)
Rec. Duration
Alarm Spot Camera No.
Preset Camera No.
