Event
40
Use the following procedure to configure settings that control terminal alarm action when a Panasonic alarm protocol alarm (site alarm) is sent
from a camera.
1 Click the [Event] button on the setup menu.
2 On the sub-menu that appears, click [Site alarm].
This will display the site alarm setting window.
3 Configure the settings for each item.
Refer to “Site alarm settings” table for details about the
settings.
• To configure the settings of a camera that is not shown on
the display, click the applicable camera number range
above the [Set] button to change the contents of the
display.
• Clicking a camera number range saves the currently
displayed camera settings.
4 Click the [Set] button.
Site alarm settings
♦Initial default
Site alarm
Item Settings Description
Site alarm Off♦ / On Specifies whether to validate the site alarm.
Port number
(from camera to ND400)
Port number input
(1818♦)
Specifies the port number that receives the site alarm.
Site alarm setup
Rec. cam. Cam.1 to Cam.64 / -- Specifies the channel of the recording camera.
Preset position Signal input
(Blank♦)
Specifies the preset position (1 to 256) during alarm input.
• When this setting is blank, the camera does not move to a
preset position.
Output terminal Off / On♦ Specifies whether an alarm signal should be output when an
event occurs.
