page 7
www.midlandradio.com
English François Español
WR-120 Owner’s Manual
Set Location:
Your WR-120 All Hazards Weather Alert Radio comes preprogrammed to
receive weather and hazard alert transmissions for all S.A.M.E. codes within
range. If this is what you want, leave the radio set to ANY.
“Any” S.A.M.E. Code: (recommended)
1. Press
MENU
to open menu options.
2. Press ▲ to scroll through menu to SET LOCATION, then press
SELECT
.
3. Press ▲ to ANY then press
SELECT
.
4. Press
MENU
to exit menu mode.
“Single” S.A.M.E. Code:
1. Press
MENU
to open menu options.
2. Press ▲ to scroll through menu to SET LOCATION, then press
SELECT
.
3. Press ▲ to SINGLE then press
SELECT
.
4. SAME 01 will be displayed. Press
SELECT
.
5. Use
►
▲
▼
or
►
to program the 6 digit S.A.M.E. code.
6. Press
SELECT
.
7. Press
MENU
to exit menu mode.
Note: In the single mode the last S.A.M.E. code programmed will
be the only one the radio alerts to, even though multiple codes can
be entered in alternate S.A.M.E. positions.
“Multiple” S.A.M.E. Code:
1. Press
MENU
to open menu options.
2. Press ▲ to scroll through menu to SET LOCATION, then press
SELECT
.
3. Press ▲ to MULTIPLE then press
SELECT
.
4. SAME 01 will be displayed. Press
SELECT
.
5. Use
►
▲
▼
or
►
to program the 6 digit S.A.M.E. code.
6. Press
SELECT
.
7. Press ▲ to advance to SAME 02.
8. Repeat steps 4-7 to program up to 25 codes.
9. Press
SELECT
.
10. Press
MENU
to exit menu mode.
Note: While in MENU mode, if no buttons are pressed for
60 seconds, the radio will automatically exit MENU mode.
