18
ENGLISH
Settings
INPUT SELECTOR
DISPLAY P.DIRECT IN
X
Setting ID number for F.C.B.S
When the unit is turned on, the display shows the ID number
for three seconds.
For a master unit, ID number 1 needs to be assigned.
For a slave unit, set any of ID numbers 2 to 4.
1
While holding DISPLAY on the unit, press X.
2
Turn INPUT SELECTOR on the unit to select an
ID number.
3
Turn the unit o.
4
Again turn the unit on.
•The setting is saved.
•The unit registered as a slave shows “SLAVE” on the
display.
NOTE
•If using this unit by itself as a stereo amplifier, set the ID
number to “0” (Default setting is “0”).
•If the ID number is set to a number other than “0”, this unit
cannot be used for standalone operation.
Setting the power amp direct mode
When a pre-amplifier is connected to this unit and the unit is
used as a power amplifier, follow the instructions below to
turn power amp direct mode on.
•The power amp direct mode is turned o in the factory
default settings.
Turning power amp direct mode on
Press and hold P.DIRECT IN on the unit for 3
seconds or longer.
“POWER AMP DIRECT” is appears on the display .
Turning power amp direct mode o
Press and hold P.DIRECT IN on the unit for 3
seconds or longer.
“POWER AMP DIRECT” disappears from the display.
NOTE
•When the power amp direct mode is on, adjustment of the
volume, balance and tone on the main unit has no eect.
Adjust the volume on the pre-amplifier.
•When the power amp direct mode is on, the main unit outputs
at maximum volume. Check the output level on the input
device before playing it and adjust the volume accordingly.
1.PM14S1U_ENG_0722.indd 18 2013/07/25 17:08:35
