Easy access to the operating mechanism, control board(s) and other components located in the header area
is accomplished through hinged panel doors that are key lockable. All bearings are permanently lubricated
requiring no scheduled maintenance. The lower spindle bearing is located inside the spindle column and will
not be exposed to salt, sweep cleaners or other floor maintenance materials that could cause failure. All shafts
and hardware are made from stainless steel.
Barrier
80
203.2
10
25.4
Header & Cover
Spindle Arm Section
Passage Panel
(1 of 3 shown)
in
cm
aT-fsT series (single) - dimensiOnal drawings
60
152.4
53
134.6
in
cm
d e f i n i T i O n s :
1. Fail-Safe: Upon loss of electrical power the turnstile center spindle will rotate freely in the entrance or exit direction
that is selected with this option from the ORDERING GUIDE.
2. Fail-Secure: Upon loss of electrical power the turnstile center spindle will remain locked in the entrance or exit
direction that is selected with this option from the ORDERING GUIDE.
3. Locked: The center spindle will always be locked in the entrance or exit direction that is selected with this option
from the ORDERING GUIDE.
4. Manual: The center spindle will always freely rotate in the entrance or exit direction that is selected with this option
from the ORDERING GUIDE.
c a u T i O n :
For safety reasons do not combine electrically controlled and manually controlled on the same center spindle.
