10
Section 1: Assembly & Set-up
APS1548, APS1560, APS1572 & APS1586 All Purpose Seeder 313-354M
5/13/08
Land Pride
Table of Contents
Special Instructions For Spike Roller
Refer to Figure 1-7:
1. Attach spike scrapers (#17) to scraper hanger (#9)
with 3/8"-16 x 1 1/4" GR5 round head square neck
bolts (#18) and hex flange lock nuts (#19). Draw nuts
up snug, do not tighten until after completing
adjustments in Section 3.
NOTE: Do not tighten bolts (#11 & #18) until after
adjustments have been made. See “Mud Scraper
Adjustment (Optional)” on page 14 for instructions.
2. Attach scraper hangers (#9) to chain guard
mount (#7) with two 3/8"-16 x 1 1/4" GR5 hex head
cap screws (#11), 3/8" flat washers (#15) and 3/8"
lock washers (#16). Secure scraper in place with hex
nuts (#13). Draw nuts up snug, do not tighten until
after completing adjustments in Section 3.
3. Attach opposite end to scraper mount (#10) with two
3/8"-16 x 1 1/4" GR5 hex head cap screws (#11),
3/8" flat washers (#15) and 3/8" lock washers (#16).
Secure cap screws with hex nuts (#13). Draw nuts up
snug, do not tighten until after completing
adjustments in Section 3.
Rear Mud Scraper Installation to Spike Roller
Figure 1-7
25606
