9
Section 1: Assembly & Set-up
5/13/08
APS1548, APS1560, APS1572 & APS1586 All Purpose Seeder 313-354M
Land Pride
Table of Contents
Rear Mud Scraper Installation to Packer Roller
Figure 1-6
25605
Roller Arm Disassembly Position
Figure 1-5
Refer to Figure 1-6 below & Figure 1-7 on page 10:
6. Pull roller arm assembly (#1) away from rear roller
end plate and insert two 1/2"-13 x 1 1/2" GR5 hex
cap screws (#12) from the inside as shown.
24977
Attach a vice grip tightly to
the spring rod at this location.
Important: Make sure there is space
between the roller arm (#1) and stop
blocks above and below the arm and
that the arm is not tight against a stop
block before attaching a vice grip to
the spring rod.
3
1
2
4
Spring Rod
SpringRod
Guide Bar
5
6
7. Reinstall roller arm assembly (#1) to the seeder side
plate with existing 3/4"-10 hex flange lock
nut (#3), 5/8"-11 GR5 hex head cap screws (#4) and
lock washers (#5). Torque all hardware including
bearing set collar screw (#2).
8. Remove vice grip from spring rod.
9. Attach left hand scraper mount (#10) to the left side
roller arm (#1) with hex flange lock nuts (#14).
Tighten lock nuts (#14) to the correct torque.
Special Instructions For Packer Roller
Refer to Figure 1-6:
1. Attach rear roller scraper (#9) to chain guard
mount (#7) with two 3/8"-16 x 1 1/4" GR5 hex head
cap screws (#11), 3/8" flat washers (#15), 3/8" lock
washers (#16) and hex nuts (#13). Draw nuts up
snug, do not tighten until after completing
adjustments in Section 3.
2. Attach opposite end to scraper mount (#10) with two
3/8"-16 x 1 1/4" GR5 hex head cap screws (#11),
3/8" flat washers (#15), 3/8" lock washers (#16) and
hex nuts (#13). Draw nuts up snug, do not tighten
until after completing adjustments in Section 3.
NOTE: Do not tighten bolts (#16) until after
adjustments have been made. See “Mud Scraper
Adjustment (Optional)” on page 14 for instructions.
