32
33 Keying priority over playback
Without switching off the repeat
playback for messages, you can start
keying.
34 CW RX pitch / TX sidetone
frequency
Select RX pitch frequency between
400Hz and 1000Hz. At the same time,
sidetone frequency changes with the
pitch frequency. This can be used to
zero in on a target signal by matching
the sidetone frequency with the RX
beat.
35 CW keying weight ratio
Change the dot/dash weight ratio. This
is usually set to AUTO.
36 Reverse CW keying auto
weight ratio
You can change the AUTO setting for
#35.
37 Bug key function
Manual TX can be enabled for dashes
only.
38 Swap dot & dash paddle
position
Swap the paddle position to suit either
right-handed or left-handed use.
39 Auto CW TX in SSB mode
Automatically switch mode to CW
transmission by simply operating the
paddle.
CW
40 Define CW tune frequency
Useful if used in combination with #39,
as there is no need to operate the dial
to zero in on a target.
41 FSK shift
42 FSK keying polarity
FSK
43 FSK tone frequency
Standard FSK operating parameters
are covered by these menus.
FM
44 Mic gain for FM
You can adjust FM mic gain (3 levels)
45 Filter bandwidth for data
communications
This enables you to pick the
appropriate DSP filter for data
communications using the filter switch
on the control panel.
46 AF input level for data
connector
Data
communicat
ions
47 AF output level for data
connector
Adjust input and output levels
independently when the TS-480 is
connected to a SoundBlaster™ card or
other external device.
